Cooper Motion Sensor Light Switch Instructions

There is motion in the detection zone.

Cooper motion sensor light switch instructions.

Instructions for a cooper outdoor motion detector location. Install your fixture near a doorway or pathway to. Repeat this procedure to restore normal operation. Apply power and wait one minute.

When unit stabilizes about 1 minute the sensor is ready to detect motion. Select a location that is 6 to 8 feet above ground level. Turn the light switch to the off position for 40 seconds and then turn back to the on position. The sensor red wire will connect to the wire which goes to the light fixture.

Unit is in override mode if there is no motion. Automatically release the button while the led is blinking. Two locations one location is the sensor and the other location is a standard 3 way switch two locations replace both 3 way switches with sensors in automatic on mode the lights turn on automatically when a person enters the room. Press and hold the on off button for 10 seconds until the indicator led blinks for the second time the led will also blink at the 5 second point.

In manual on mode the lights are turned on by pressing the pushbutton. The sensor green wire will connect to the ground wire in the wallbox. Reposition the sensor. Turn the power back on at the circuit breaker.

The sensor blue wire is not used and should be capped off with a wire nut. Motion is detected the lights will turn on. Rotating the light adjustment knob will control at what level of brightness the motion sensor will turn the light on when it is in automatic mode not test mode. Switch or in the unlikely event of a failure of the motion sensor.

The sensor black wire will connect to the hot wire in the wallbox. Set the switch to the auto mode. In either mode the. Turn off power at the main fuse or breaker box.

The lights will turn off 5 seconds after motion is no longer detected. Match up screw holes on the cover plate with the junction.