Cord Drawn Curtain Tracks Instructions

8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor.

Cord drawn curtain tracks instructions.

To drill holes identify where the holes should be positioned and mark the track. Hook cord over the lug on carrier 2 to secure it. Curtain track features and how to install. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket.

Using a small bit drill pilot holes centered in the slot through the top of the track. Then remove master carrier from the track. Then feed cord around and over the top pulley g pass cord back through ovelrap master slide. Add those two.

Cord on overlap master carrier as original. Tension cord and tie off h. Remove the curtain rod from the. Measure also the distance from the floor to the top of the curtain rod.

If you re removing an old cord you can untie it. Most curtain tracks do not have the mounting holes pre drilled. Click here for how to mend it. First you ll want to remove the curtain along with the curtain hooks from the rod and carriers.

Next place the rod face down on a flat surface. I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. Remove the curtains from the traverse rods so you can access the cording.

Replace sliders at each end. How to thread cord on curtain rails. Measure the rod s length while it is still on the wall. How to fit new cord to curtain tracks take measurements.

2 pull track apart at the centre. Draw the cord until the right hand carrier 1 is as far to the right as possible. Standard drill bits work fine on all aluminum tracks. 3 unhook cord from master carrier and allow to drop inside track.

Place pulley 2 onto track section and secure with screws. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud. Re attach track onto brackets and re hang curtains.